Cisco AP775A - Nexus Converged Network Switch 5010 - Show Inventory

Send comments to nx5000-docfeedback@cisco.com
1-87
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
show inventory
show inventory
To display the physical inventory information for the switch hardware, use the show inventory
command.
show inventory [fex chassis_ID]
Syntax Description
Command Default Displays all hardware inventory information.
Command Modes EXEC mode
Command History
Examples This example shows how to display the switch hardware inventory information:
switch# show inventory
This example shows how to display the hardware inventory information for an attached Fabric Extender:
switch# show inventory fex 101
Related Commands
fex chassis_ID (Optional) Specifies the Fabric Extender chassis ID. Chassis ID is 100 to
199.
Release Modification
4.0(0)N1(1a) This command was introduced.
4.0(1a)N2(1) This command was modified to provide Fabric Extender support.
Command Description
show hardware
internal
Displays information about the physical hardware.
show module Displays information about the modules.