Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
4-11
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 4 Fabric Extender Commands
serial
serial
To assign a serial number to a Fabric Extender, use the serial command. To remove the serial number,
use the no form of this command.
serial serial_string
no serial
Syntax Description
Command Default None
Command Modes Fabric Extender configuration mode
Command History
Usage Guidelines The serial number string you define with the serial command must match the serial number of the Fabric
Extender. If you configure a serial number and then you use the fex associate command to associate the
corresponding chassis ID to the switch, the association will succeed only if the Fabric Extender reports
a matching serial number string.
Caution Configuring a serial number other than that of the given Fabric Extender will force the Fabric Extender
offline.
Examples This example shows how to specify a serial number for a Fabric Extender:
switch# configure terminal
switch(config)# fex 101
switch(config-fex)# serial Rack16_FEX101
This example shows how to remove a serial number from a Fabric Extender:
switch# configure terminal
switch(config)# fex 101
switch(config-fex)# no serial
serial_string Serial number string for the Fabric Extender. The string is alphanumeric,
case sensitive, and has a maximum length of 20 characters.
Release Modification
4.0(1a)N2(1) This command was introduced.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English