Send comments to nx5000-docfeedback@cisco.com
8-138
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
system default zone distribute full
system default zone distribute full
To configure default values for distribution to a zone set, use the system default zone distribute full
command. To revert to the defaults, use the no form of the command.
system default zone distribute full
no system default zone distribute full
Syntax Description This command has no arguments or keywords.
Command Default Distribution to active zone sets only.
Command Modes Configuration mode
Command History
Usage Guidelines This command distributes the default values for the default zone to all VSANs. The default values are
used when you initially create a VSAN and it becomes active. If you do not want to use the default
values, use the zoneset distribute full vsan command to distribute the operational values for the default
zone.
The system default zone distribute full command should only be used in conjunction with VSANs that
have not yet been created; it has no effect on existing VSANs.
Because VSAN 1 is the default VSAN and is always present, this command has no effect on it.
Examples The following example distributes default values to the full zone set:
switch(config)# system default zone distribute full
The following example distributes default values to the active zone set only:
switch(config)# no system default zone distribute full
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
zoneset distribute full
vsan
Distributes the operational values for the default zone to all zone sets.
show system default
zone
Displays default values for the default zone.
To Next Page
Loading...
Need help?
General
