Send comments to nx5000-docfeedback@cisco.com
1-71
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
setup
setup
To enter the basic device setup dialog, use the setup command.
setup [ficon]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines The setup script uses the factory-default values, not the values that you have configured. You can exit
the dialog at any point by pressing Ctrl-C.
Examples This example shows how to enter the basic device setup script:
switch# setup
Related Commands
ficon (Optional) Runs the basic ficon setup command facility.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show running-config Displays the running configuration.
To Next Page
Loading...
