Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
3-7
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show ip igmp snooping
show ip igmp snooping
To display the Internet Group Management Protocol (IGMP) snooping configuration of the switch, use
the show ip igmp snooping command.
show ip igmp snooping [explicit-tracking vlan vlan-id | groups [detail | vlan vlan-id] | mrouter
[vlan vlan-id] | querier [vlan vlan-id] | vlan vlan-id]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the IGMP snooping configuration of the switch:
switch# show ip igmp snooping
Related Commands
explicit-tracking (Optional) Displays information about the explicit host-tracking status for
IGMPv3 hosts. If you provide this keyword, you must specify a VLAN.
vlan vlan-id (Optional) Specifies a VLAN. Valid values are 1 to 4094.
groups (Optional) Displays information for IGMP group address.
detail (Optional) Displays detailed information for the group.
mrouter (Optional) Displays information about dynamically detected multicast
routers.
querier (Optional) Displays information about the snooping querier if defined.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
ip igmp snooping
(EXEC)
Globally enables IGMP snooping. IGMP snooping must be globally enabled
in order to be enabled on a VLAN.
ip igmp snooping
(VLAN)
Enables IGMP snooping on the VLAN interface.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English