Send comments to nx5000-docfeedback@cisco.com
5-24
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
show policy-map interface brief
show policy-map interface brief
To display policy maps applied to interfaces in a brief format, use the show policy-map interface brief
command.
show policy-map interface brief
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display assigned policy maps in a brief format:
switch(config)# show policy-map interface brief
Interface/VLAN [Status]:INP QOS OUT QOS INP QUE OUT QUE
================================================================================
port-channel5 [Active]: default-in-po default-out-p
port-channel20 [Active]: default-in-po default-out-p
port-channel30 [Active]: default-in-po default-out-p
port-channel37 [Active]: default-in-po default-out-p
port-channel50 [Active]: default-in-po default-out-p
Ethernet2/2 [Active]: default-in-po default-out-p
Ethernet2/3 [Active]: default-in-po default-out-p
==================================================================================
Related Commands
Release Modification
4.1(3)N1(1) This command was introduced.
Command Description
show policy-map Displays policy maps and statistics.
To Next Page
Loading...
