Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
2-43
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
private-vlan synchronize
private-vlan synchronize
To map the secondary VLANs to the same MST instance as the primary VLAN, use the private-vlan
synchronize command.
private-vlan synchronize
Syntax Description This command has no keywords or arguments.
Command Default None
Command Modes MST configuration mode
Command History
Usage Guidelines If you do not map secondary VLANs to the same MST instance as the associated primary VLAN when
you exit the MST configuration mode, the device displays a warning message that lists the secondary
VLANs that are not mapped to the same instance as the associated VLAN. The private-vlan
synchronize command automatically maps all secondary VLANs to the same instance as the associated
primary VLANs.
Examples This example shows how to initialize PVLAN synchronization:
switch(config)# spanning-tree mst configuration
switch(config-mst)# private-vlan synchronize
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree
mst configuration
Displays information about the MST protocol.
spanning-tree mst
configuration
Enters MST configuration mode.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English