Send comments to nx5000-docfeedback@cisco.com
4-20
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 4 Fabric Extender Commands
show interface transceiver fex-fabric
show interface transceiver fex-fabric
To display information about all transceivers connected to fabric interfaces, use the show interface
transceiver fex-fabric command.
show interface transceiver fex-fabric [calibration | detail]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display information about all transceivers that connect to fabric interfaces:
switch# show interface transceiver fex-fabric
Related Commands
calibration (Optional) Displays detailed calibration information about the transceiver.
detail (Optional) Displays detailed diagnostic information about the transceiver.
Release Modification
4.0(1a)N2(1) This command was introduced.
Command Description
show fex Displays all configured Fabric Extender chassis connected to the switch.
To Next Page
Loading...
