Send comments to nx5000-docfeedback@cisco.com
7-18
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
logging timestamp
logging timestamp
Use the logging timestamp command to set the logging timestamp units. By default, the units are
seconds.
To reset the logging timestamp units to the default, use the no form of this command.
logging timestamp {microseconds | milliseconds | seconds}
no logging timestamp {microseconds | milliseconds | seconds}
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples This example shows how to set the logging timestamp units to microseconds:
switch(config)# logging timestamp microseconds
Related Commands
microseconds |
milliseconds | seconds
Selects the units to use for logging timestamps. The default units are
seconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show logging
timestamp
Displays the logging timestamp configuration.
To Next Page
Loading...
