Send comments to nx5000-docfeedback@cisco.com
1-42
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
feature tacacs+
feature tacacs+
To enable TACACS+, use the feature tacacs+ command. To disable TACACS+, use the no form of this
command.
feature tacacs+
no feature tacacs+
Syntax Description This command has no arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines You must use the feature tacacs+ command before you configure TACACS+.
Note When you disable TACACS+, the Cisco NX-OS software removes the TACACS+ configuration.
Examples This example shows how to enable TACACS+:
switch(config)# feature tacacs+
This example shows how to disable TACACS+:
switch(config)# no feature tacacs+
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show tacacs+ Displays TACACS+ information.
To Next Page
Loading...
