Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
2-62
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
spanning-tree mst hello-time
spanning-tree mst hello-time
To set the hello-time delay timer for all the instances on the switch, use the spanning-tree mst hello-time
command. To return to the default settings, use the no form of this command.
spanning-tree mst hello-time seconds
no spanning-tree mst hello-time
Syntax Description
Command Default 2 seconds.
Command Modes Configuration mode
Command History
Usage Guidelines If you do not specify the hello-time value, the value is calculated from the network diameter.
Examples This example shows how to set the hello-time delay timer:
switch(config)# spanning-tree mst hello-time 3
Related Commands
seconds Number of seconds to set the hello-time delay timer for all the instances on
the switch; the range of valid values is from 1 to 10 seconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree
mst
Displays the information about the MST protocol.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English