Send comments to nx5000-docfeedback@cisco.com
6-86
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
radius-server timeout
radius-server timeout
To specify the time between retransmissions to the RADIUS servers, use the radius-server timeout
command. To revert to the default, use the no form of this command.
radius-server timeout seconds
no radius-server timeout seconds
Syntax Description
Command Default 1 second.
Command Modes Configuration mode
Command History
Examples This example shows how to configure the timeout interval:
switch(config)# radius-server timeout 30
This example shows how to revert to the default interval:
switch(config)# no radius-server timeout 30
Related Commands
seconds Number of seconds between retransmissions to the RADIUS server. The
range is from 1 to 60 seconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.
To Next Page
Loading...
