Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-123
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
rscn abort
rscn abort
To cancel a Registered State Change Notification (RSCN) configuration on a VSAN, use the rscn abort
command. To reverse the cancellation, use the no form of the command.
rscn abort vsan vsan-id
no rscn abort vsan vsan-id
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples The following example cancels an RSCN configuration on VSAN 1:
switch(config)# rscn abort vsan 1
Related Commands
vsan vsan-id Specifies a VSAN where the RSCN configuration should be cancelled. The
ID of the VSAN is from 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
rscn commit Commits a pending RSCN configuration on a specified VSAN.
rscn distribute Enables the distribution of an RSCN configuration.
rscn event-tov Configures an RSCN event timeout.
clear rscn session vsan Clears the RSCN session for a specified VSAN.
show rscn Displays RSCN configuration information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English