Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
1-93
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
show module
show module
To display module information, use the show module command.
show module [module-number | fex [chassis_ID | all]]
Syntax Description
Command Default Displays module information for all modules in the switch chassis.
Command Modes EXEC mode
Command History
Examples This example shows how to display information for all modules in the chassis:
switch# show module
This example shows how to display information for a specific module:
switch# show module 2
This example shows how to display information about an attached Fabric Extender:
switch# show module fex 101
This example shows how to display information about all attached Fabric Extender units:
switch# show module fex all
Related Commands
module-number (Optional) Number of the module. The valid range is from 1 to 3.
fex (Optional) Displays information about the attached Fabric Extender units.
chassis_ID (Optional) Specifies a Fabric Extender chassis ID. Chassis ID is 100 to 199.
all (Optional) Displays information about all the attached Fabric Extender units.
Release Modification
4.0(0)N1(1a) This command was introduced.
4.0(1a)N2(1) This command was modified to provide Fabric Extender support.
Command Description
show hardware
internal
Displays information about the physical hardware.
show inventory Displays hardware inventory information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English