Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
6-85
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
radius-server retransmit
radius-server retransmit
To specify the number of times that the switch should try a request with a RADIUS server, use the
radius-server retransmit command. To revert to the default, use the no form of this command.
radius-server retransmit count
no radius-server retransmit count
Syntax Description
Command Default 1 retransmission.
Command Modes Configuration mode
Command History
Examples This example shows how to configure the number of retransmissions to RADIUS servers:
switch(config)# radius-server retransmit 3
This example shows how to revert to the default number of retransmissions to RADIUS servers:
switch(config)# no radius-server retransmit 3
Related Commands
count Number of times that the switch tries to connect to a RADIUS server before
reverting to local authentication. The range is from 1 to 5 times.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show radius-server Displays RADIUS server information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English