Send comments to nx5000-docfeedback@cisco.com
3-16
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show running-config spanning-tree
show running-config spanning-tree
To display the running configuration for the Spanning Tree Protocol (STP), use the show
running-config spanning-tree command.
show running-config spanning-tree [all]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display information on the running STP configuration:
switch# show running-config spanning-tree
This example shows how to display detailed information on the running STP configuration:
switch# show running-config spanning-tree all
Note Display output differs slightly depending on whether you are running Rapid PVST+ or MST.
Related Commands
all (Optional) Displays current STP operating information including default
settings.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree Displays information about STP.
To Next Page
Loading...
