Cisco AP775A - Nexus Converged Network Switch 5010 - Show Policy-Map

Send comments to nx5000-docfeedback@cisco.com
5-22
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
show policy-map
show policy-map
To display policy maps and statistics, use the show policy-map command.
show policy-map [type {qos | queuing|network-qos}] [policy-map-name]
Syntax Description
Defaults None.
Command Modes Any command mode
Command History
Usage Guidelines When you enter the command show policy-map with no arguments or keywords, the system also
displays the Control Plane Policing (CoPP) information.
This command does not require a license.
Examples This example shows how to display a named policy map:
switch(config)# show policy-map abc
switch(config)# show policy-map type queuing
Related Commands
type (Optional) Specifies the component type to display.
qos Displays policy maps of type qos only.
queuing Displays policy maps of type queuing only.
policy-map-name (Optional) Displays a named policy map.
Release Modification
4.1(3)N1(1) This command was introduced.
Command Description
class-map Creates or modifies a class map.