EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Cisco AP775A - Nexus Converged Network Switch 5010
792 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #638 background imageLoading...
Page #638 background image
Send comments to nx5000-docfeedback@cisco.com
8-90
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
interface fc
interface fc
To configure a Fibre Channel interface on a Cisco Nexus 5000 Series switch, use the interface fc
command. The interface fc command enters interface configuration mode, which includes five
commands (each with a no form).
To revert to defaults, use the no form of the command.
interface fc slot/port
channel-group {group-id [force] | auto}
fcdomain rcf-reject vsan vsan-id
fcsp {auto-active | auto-passive | on | off} [timeout-period]
fspf {cost link-cost vsan vsan-id | dead-interval seconds vsan vsan-id | hello-interval seconds
vsan vsan-id | passive vsan vsan-id | retransmit-interval seconds vsan vsan-id}
switchport
no interface fc slot/port
no channel-group {group-id [force] | auto}
no fcdomain rcf-reject vsan vsan-id
no fcsp {auto-active | auto-passive | on | off}
no fspf {cost link-cost vsan vsan-id | dead-interval seconds vsan
vsan-id | hello-interval
seconds vsan vsan-id | passive vsan vsan-id | retransmit-interval seconds vsan vsan-id}
switchport
Syntax Description
Command Default Disabled.
Command Modes Configuration mode
slot/port Specifies a slot number and port number.
channel-group Adds to or removes from a Port Channel.
group-id Specifies a Port Channel group number from 1 to 128.
force Forcefully adds a port.
auto Enables autocreation of port channels.
fcdomain Enters the interface mode.
rcf-reject Configures the rcf-reject flag.
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
fspf Configures FSPF parameters.
cost link-cost Configures FSPF link cost. The range is 1 to 65535.
dead-interval seconds Configures FSPF dead interval in seconds. The range is 2 to 65535.
hello-interval seconds Configures FSPF hello-interval. The range is 1 to 65535.
passive Enables or disables FSPF on the interface.
retransmit-interval
seconds
Configures FSPF retransmit interface in seconds. The range is 1 to 65535.

Table of Contents

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals