Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
7-15
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
logging monitor
logging monitor
Use the logging monitor command to enable the device to log messages to the monitor (terminal line).
This configuration applies to Telnet and SSH sessions.
To disable monitor log messages, use the no form of this command.
logging monitor [severity-level]
no logging monitor
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples This example shows how to enable monitor log messages:
switch(config)# logging monitor
Related Commands
severity-level (Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show logging monitor Displays the status of monitor logging.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English