Send comments to nx5000-docfeedback@cisco.com
6-8
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
aaa authentication login mschap enable
aaa authentication login mschap enable
To enable Microsoft Challenge Handshake Authentication Protocol (MSCHAP) authentication at login,
use the aaa authentication login mschap enable command. To revert to the default, use the no form of
this command.
aaa authentication login mschap enable
no aaa authentication login mschap enable
Syntax Description This command has no arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History
Examples This example shows how to enable MSCHAP authentication:
switch(config)# aaa authentication login mschap enable
This example shows how to disable MSCHAP authentication:
switch(config)# no aaa authentication login mschap enable
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show aaa
authentication
Displays the status of MSCHAP authentication.
To Next Page
Loading...
