Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
3-2
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show interface mac-address
show interface mac-address
To display the information about the MAC address, use the show interface mac-address command.
show interface [type slot/port] mac-address
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines If you do not specify an interface, the system displays all the MAC addresses.
Examples This example shows how to display the information on MAC addresses for the entire switch:
switch# show interface mac-address
Related Commands
type slot/port (Optional) Specifies the interface for which MAC addresses should be
displayed. The type can be either ethernet. Specify the appropriate slot or
virtual interface group number and port number.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
mac-address-table
static
Adds static entries to the MAC address table or configures a static MAC
address with IGMP snooping disabled for that address.
show
mac-address-table
Displays information on the MAC address table.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English