Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-125
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
rscn distribute
rscn distribute
To enable distribution of a Registered State Change Notification (RSCN) configuration, use the rscn
distribute command. To disable the distribution, use the no form of the command.
rscn distribute
no rscn distribute
Syntax Description This command has no arguments or keywords.
Command Default RSCN timer distribution is disabled.
Command Modes Configuration mode
Command History
Usage Guidelines The RSCN timer configuration must be the same on all switches in the VSAN. Cisco Fabric Service
(CFS) automatically distributes the RSCN timer configuration to all switches in a fabric. Only the RSCN
timer configuration is distributed.
Examples The following example enables the distribution of an RSCN configuration:
switch(config)# rscn distribute
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
rscn abort Cancels a pending RSCN configuration on a specified VSAN.
rscn commit Applies a pending RSCN configuration.
rscn event-tov Configures an RSCN event timeout.
clear rscn session Clears the RSCN session for a specified VSAN.
show rscn Displays RSCN configuration information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English