Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
1-106
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
show system reset-reason
show system reset-reason
To display the reset history for the switch, use the show system reset-reason command.
show system reset-reason [fex chassis_ID]
Syntax Description
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the reset-reason history for the switch:
switch# show system reset-reason
This example shows how to display the reset-reason history for an attached Fabric Extender:
switch# show system reset-reason fex 101
fex chassis_ID (Optional) Specifies the Fabric Extender chassis ID. Chassis ID is 100 to
199.
Release Modification
4.0(0)N1(1a) This command was introduced.
4.0(1a)N2(1) This command was modified to provide Fabric Extender support.