Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
9-33
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 9 Fibre Channel Show Commands
show loadbalancing
show loadbalancing
To display load-balancing status for specific unicast flows, use the show loadbalancing command.
show loadbalancing vsan vsan-id source-fcid dest-fcid [exchange-id]
Syntax Description
Command Default None
Command Modes EXEC mode.
Command History
Examples The following example displays the load-balancing information for the specified source and destination
in VSAN 3:
switch# show loadbalancing vsan 3 0x3345 0x2546
vsan vsan-id Displays FLOGI database entries based on the FCID allocated. The format
is 0xhhhhhh.
source-fcid Displays loadbalancing status for the specified source FCID. The format is
0xhhhhhh.
dest-fcid Displays loadbalancing status for the specified destination FCID. The format
is 0xhhhhhh.
exchange-id (Optional) Displays loadbalancing status for the specified exchange. The
format is 0xhhhhhh.
Release Modification
4.0(0)N1(1a) This command was introduced.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English