Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
10-5
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 10 Vpc Commands
show startup-config vpc
show startup-config vpc
To display virtual port-channel (vPC) configuration information in the startup-configuration, use the
show startup-config vpc command.
show startup-config vpc [all]
Syntax Description[
Defaults None
Command Modes Any command mode.
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the vPC information in the startup configuration:
switch(config)# show startup-config vpc
version 4.1(2)
feature vpc
vpc domain 1
interface port-channel10
vpc peer-link
interface port-channel20
vpc 100
Related Commands
all (Optional) Displays startup-configuration information for all vPCs.
Release Modification
4.1(3)N1(1) This command was introduced.
Command Description
show vpc brief Displays information about vPCs. If the feature is not enabled, the system
displays an error when you enter this command.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English