Send comments to nx5000-docfeedback@cisco.com
6-134
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 6 Security Commands
tacacs-server deadtime
tacacs-server deadtime
To set a periodic time interval where a nonreachable (nonresponsive) TACACS+ server is monitored for
responsiveness, use the tacacs-server deadtime command. To disable the monitoring of the
nonresponsive TACACS+ server, use the no form of this command.
tacacs-server deadtime minutes
no tacacs-server deadtime minutes
Syntax Description
Command Default 0 minutes.
Command Modes Configuration mode
Command History
Usage Guidelines Setting the time interval to zero disables the timer. If the dead-time interval for an individual TACACS+
server is greater than zero (0), that value takes precedence over the value set for the server group.
When the dead-time interval is 0 minutes, TACACS+ server monitoring is not performed unless the
TACACS+ server is part of a server group and the dead-time interval for the group is greater than
0 minutes.
You must use the feature tacacs+ command before you configure TACACS+.
Examples This example shows how to configure the dead-time interval and enable periodic monitoring:
switch(config)# tacacs-server deadtime 10
This example shows how to revert to the default dead-time interval and disable periodic monitoring:
switch(config)# no tacacs-server deadtime 10
Related Commands
time Specifies the time interval in minutes. The range is from 1 to 1440.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
deadtime Sets a dead-time interval for monitoring a nonresponsive RADIUS or
TACACS+ server group.
feature tacacs+ Enables TACACS+.
show tacacs-server Displays TACACS+ server information.
To Next Page
Loading...
