Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
1-41
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
feature private-vlan
feature private-vlan
To enable private VLANs, use the feature private-vlan command. To return to the default settings, use
the no form of this command.
feature private-vlan
no feature private-vlan
Syntax Description None
Command Default Private VLANs are disabled.
Command Modes Configuration mode
Command History
Usage Guidelines The private VLAN commands are not available until you enable the private VLAN feature.
You cannot disable the private VLANs if there are operational ports on the switch that are in private
VLAN mode.
Note A PVLAN isolated port on a Cisco Nexus 5000 Series switch running the current release of Cisco
NX-OS does not support IEEE 802.1q encapsulation and cannot be used as a trunk port.
Examples This example shows how to enable private VLAN functionality on the switch:
switch(config)# feature private-vlan
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
private-vlan Configures a VLAN as either a community, isolated, or primary private
VLAN.
show vlan private-vlan Displays information on private VLANs. If the feature is not enabled, this
command is not available.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English