Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
2-16
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
delay (interface)
delay (interface)
To set a delay value for an interface, use the delay command. To restore the default delay value, use the
no form of this command.
delay tens-of-microseconds
no delay
Syntax Description
Command Default 10 μsec
Command Modes Interface configuration mode
Command History
Examples The following example shows how to set a delay of 30,000 microseconds on an interface:
switch(config)# interface ethernet 1/1
switch(config-if)# delay 3000
Related Commands
tens-of-microseconds Specifies the throughput delay in tens of microseconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show interface Displays the interface configuration information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English