Cisco AP775A - Nexus Converged Network Switch 5010 - Fcsp Reauthenticate

Send comments to nx5000-docfeedback@cisco.com
8-73
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fcsp reauthenticate
fcsp reauthenticate
To reauthenticate a Fibre Channel or virtual Fibre Channel interface, use the fcsp reauthenticate
command. Use the no form of the command to revert to factory defaults.
fcsp reauthenticate interface { fc slot/port | vfc vfc-id }
no fcsp reauthenticate interface { fc slot/port | vfc vfc-id }
Syntax Description
Command Default 30 seconds
Command Modes EXEC mode
Command History
Examples The following example configures the FCSP reauthentication on a virtual Fibre Channel interface:
switch# fcsp reauthenticate vfc 1
Related Commands
interface Specifies the interface on which to perform the reauthentication.
interface fc slot/port Specifies the Fibre Channel interface by slot and port number.
vfc vfc-id Specifies the virtual Fibre Channel interface by virtual interface group
number and virtual interface ID.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
fcsp enable Enable FC-SP.
show fcsp Displays configured FC-SP information.