Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
5-17
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
priority-flow-control
priority-flow-control
To set the (priority-flow-control) PFC mode for the selected interface, use the priority-flow-control
command.
priority-flow-control mode {auto | on}
Syntax Description
Command Default None
Command Modes Interface configuration mode
Command History
Examples This example shows how to force-enable PFC on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# priority-flow-control mode on
Related Commands
auto Negotiates PFC capability.
on Force-enables PFC.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
flowcontrol Sets link-level flow control for the selected interface.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English