Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
2-44
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
revision
revision
To set the revision number for the Multiple Spanning Tree (MST) region configuration, use the revision
command. To return to the default settings, use the no form of this command.
revision version
no revision version
Syntax Description
Command Default Revision 0.
Command Modes MST configuration mode
Command History
Usage Guidelines Two or more switches with the same VLAN mapping and name are considered to be in different MST
regions if the configuration revision numbers are different.
Caution Be careful when using the revision command to set the revision number of the MST region configuration
because a mistake can put the switch in a different region.
Examples This example shows how to set the revision number of the MST region configuration:
switch(config)# spanning-tree mst configuration
switch(config-mst)# revision 5
Related Commands
version Revision number for the MST region configuration; the range of valid values
is from 0 to 65535.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree
mst
Displays information about the MST protocol.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English