Cisco AP775A - Nexus Converged Network Switch 5010 - Logging Module

Send comments to nx5000-docfeedback@cisco.com
7-14
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
logging module
logging module
Use the logging module command to enable module log messages. Set a specified severity level or use
the default.
To disable module log messages, use the no form of this command.
logging module [severity-level]
no logging module
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples This example shows how to enable module log messages:
switch(config)# logging module
Related Commands
severity-level (Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition—default level
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show logging module Displays the module logging status.