Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-87
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fspf passive
fspf passive
To disable the FSPF protocol for selected interfaces, use the fspf passive command. To revert to the
default state, use the no form of the command.
fspf passive vsan vsan-id
no fspf passive vsan vsan-id
Syntax Description
Command Default FSPF is enabled.
Command Modes Interface configuration mode
Command History
Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces.
By default, FSPF is enabled on all E ports and TE ports. FSPF can be disabled by setting the interface as
passive using the fspf passive command. FSPF must be enabled on the ports at both ends of the ISL for
the protocol to operate correctly.
Examples The following example disables the FSPF protocol for the selected interface on VSAN 1:
switch(config)# interface fc 2/1
switch(config-if)# fspf passive vsan 1
Related Commands
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show fspf interface Displays information for each selected interface.
show interface fc Displays an interface configuration for a specified FCIP interface.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English