Send comments to nx5000-docfeedback@cisco.com
8-85
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fspf enable
fspf enable
To enable FSPF for a VSAN, use the fspf enable command. To disable FSPF routing protocols, use the
no form of the command.
fspf enable vsan vsan-id
no fspf enable vsan vsan-id
Syntax Description
Command Default Enabled.
Command Modes Configuration mode
Command History
Usage Guidelines This command configures FSPF on VSANs globally.
Examples The following example enables FSPF in VSAN 5 and disables FSPF in VSAN 7:
switch(config)# fspf enable vsan 5
switch(config)# no fspf enable vsan 7
Related Commands
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
fspf config vsan Configures FSPF features for a VSAN.
show fspf interface Displays information for each selected interface.
To Next Page
Loading...
