Send comments to nx5000-docfeedback@cisco.com
8-150
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone merge-control restrict vsan
zone merge-control restrict vsan
To restrict zone database merging, use the zone merge-control restrict vsan command. To disable this
feature, use the no form of the command.
zone merge-control restrict vsan vsan-id
no zone merge-control restrict vsan vsan-id
Syntax Description
Command Default Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines If merge control is set to restricted and the two databases are not identical, the merge fails and ISLs
between the switches become isolated.
Examples The following example shows how to set zone merge control for VSAN 10 to restricted:
switch(config)# zone merge-control restrict vsan 10
Related Commands
vsan vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
Release 4.0 This command was introduced.
Command Description
show zone Displays zone information.
To Next Page
Loading...
