Send comments to nx5000-docfeedback@cisco.com
3-10
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show mac-address-table count
show mac-address-table count
To display the number of entries currently in the MAC address table, use the show mac-address-table
count command.
show mac-address-table count [address EEEE.EEEE.EEEE] [dynamic | static] [interface {type
slot/port | port-channel number}] [vlan vlan-id]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows how to display the number of dynamic entries currently in the MAC address table:
switch# show mac-address-table count dynamic
Related Commands
address
EEEE.EEEE.EEEE
(Optional) Displays a count of the MAC address table entries for a specific
address.
dynamic (Optional) Displays a count of the dynamic MAC addresses.
static (Optional) Displays a count of the static MAC addresses.
interface type slot/port |
port-channel number
(Optional) Specifies the interface. Use either the type of interface, the slot
number, and the port number, or the EtherChannel number.
vlan vlan-id (Optional) Displays information for a specific VLAN; the range of valid
values is from 1 to 4094.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show
mac-address-table
Displays information about the MAC address table.
To Next Page
Loading...
