Cisco AP775A - Nexus Converged Network Switch 5010 - Session-Limit

Send comments to nx5000-docfeedback@cisco.com
1-72
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
session-limit
session-limit
To configure the maximum number of the concurrent virtual terminal sessions on a device, use the
session-limit command. To revert to the default, use the no form of this command.
session-limit sessions
no session-limit sessions
Syntax Description
Command Default 32 sessions.
Command Modes Terminal line configuration
Command History
Examples This example shows how to configure the maximum number of concurrent virtual terminal sessions:
switch# configure terminal
switch(config)# line vty
switch(config-line)# session-limit 48
This example shows how to revert to the default maximum number of concurrent virtual terminal
sessions:
switch# configure terminal
switch(config)# line vty
switch(config-line)# no session-limit 48
Related Commands
sessions Maximum number of sessions. The range is from 1 to 64.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
line vty Enters the virtual terminal configuration mode.
show running-config Displays the running configuration.