Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-127
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
san-port-channel persistent
san-port-channel persistent
To convert an autocreated SAN port channel to a persistent SAN port channel, use the san-port-channel
persistent command.
san-port-channel port-channel-id persistent
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Usage Guidelines This command is not reversible. A user-created channel group cannot be converted to an autocreated
channel group.When the san-port-channel persistent command is applied to an autocreated channel
group, the channel group number does not change and the member ports properties change to those of a
user-created channel group. The channel mode remains active.
Examples The following example shows how to change the properties of an autocreated channel group to a
persistent channel group:
switch# san-port-channel 10 persistent
Related Commands
port-channel-id Specifies the port channel ID. The range is 1 to 128.
persistent Converts the autocreated SAN port channel to a persistent SAN port channel
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
san-port-channel
protocol
Enables the SAN port channel protocol.
show interface
port-channel
Displays SAN port channel interface information.
show port-channel Displays SAN port channel information.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English