Cisco AP775A - Nexus Converged Network Switch 5010

Send comments to nx5000-docfeedback@cisco.com
8-115
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
port-security enable
port-security enable
To enable port security, use the port-security enable command. To disable port security, use the no form
of the command.
port-security enable
no port-security enable
Syntax Description This command has no other arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines Entering the port-security enable command enables the other commands that are used to configure port
security.
Examples The following example shows how to enable port security:
switch(config)# port-security enable
The following example shows how to disable port security:
switch(config)# no port-security enable
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show port-security Displays port security information.