Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
1-33
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
end
end
To end the current configuration session and return to EXEC mode, use the end command in
configuration mode.
end
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Configuration mode
Command History
Usage Guidelines This command returns you to EXEC mode regardless of which configuration mode you are in. Use this
command when you are done configuring the system and you want to return to EXEC mode to perform
verification steps.
Examples In the following example, the end command is used to exit from interface configuration mode and return
to EXEC mode. A show command is used to verify the configuration.
switch# configure terminal
switch(config)# interface ethernet 1/1
switch(config-if)# switchport host
switch(config-if)# end
switch# show interface ethernet 1/1
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
exit (EXEC) Terminates the active terminal session by logging off the router.
exit (global) Exits from the current configuration mode.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English