Send comments to nx5000-docfeedback@cisco.com
5-3
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
flowcontrol
flowcontrol
To enable IEEE 802.3x link-level flow control for the selected interface, use the flow-control command.
flowcontrol [receive {on | off}] [transmit {on | off}]
Syntax Description
Command Default None
Command Modes Interface configuration mode
Command History
Examples This example shows how to enable flow control for traffic received on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# flowcontrol receive on
Related Commands
receive {on | off} (Optional) Sets flow control in the receive direction.
transmit {on | off} (Optional) Sets flow control in the transmit direction.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
priority-flow-control Sets the PFC mode for the selected interface.
To Next Page
Loading...
