Send comments to nx5000-docfeedback@cisco.com
8-67
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fcs virtual-device-add
fcs virtual-device-add
To include a virtual device in a query about zone information from an FCS, use the fcs
virtual-device-add command. To remove a virtual device, use the no form of the command.
fcs virtual-device-add [vsan-ranges vsan-ids]
no fcs virtual-device-add [vsan-ranges vsan-ids]
Syntax Description
Command Default Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines VSAN ranges are entered as vsan-ids-vsan-ids. When you specify more than one range, separate each
range with a comma. If no range is specified, the command applies to all VSANs.
Examples The following example shows how to add to one range of VSANs:
switch(config)# fcs virtual-device-add vsan-ranges 2-4
The following example shows how to add to more than one range of VSANs:
switch(config)# fcs virtual-device-add vsan-ranges 2-4,5-8
Related Commands
vsan-ranges vsan-ids (Optional) Specifies one or multiple ranges of VSANs. The range is 1 to
4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show fcs Displays fabric configuration server information.
To Next Page
Loading...
