Send comments to nx5000-docfeedback@cisco.com
7-43
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
show ntp statistics
show ntp statistics
To display Network Time Protocol (NTP) statistics, use the show ntp statistics command.
show ntp statistics {io | local | memory | peer {ipaddr address | name name1 [..nameN]}
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example displays statistics for NTP:
switch(config)# show ntp statistics local
Related Commands
io Show the input-output statistics.
local Show the counters maintained by the local NTP.
memory Show the statistics counters related to memory code.
peer Show the per-peer statistics counter of a peer.
ipaddr address Displays statistics for the peer with the configured IPv4 or IPv6 address. The
IPv4 address format is dotted decimal, x.x.x.x. The IPv6 address format is
hexadecimal A:B::C:D.
name name1 [..nameN] Displays statistics for one or more named peers.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
clear ntp statistics Clears NTP statistics
To Next Page
Loading...
