Send comments to nx5000-docfeedback@cisco.com
1-112
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 1 Basic System Commands
speed
speed
To configure the transmit and receive speed for the console port, use the speed command. To revert to
the default, use the no form of this command.
speed speed
no speed speed
Syntax Description
Command Default The default console port speed is 9600 bits per second.
Command Modes Terminal line configuration
Command History
Usage Guidelines You can configure the console port only from a session on the console port.
Examples This example shows how to configure the speed for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# speed 57600
This example shows how to revert to the default speed for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# no speed 57600
Related Commands
speed Speed in bits per second. Valid speeds are 300, 1200, 2400, 4800, 9600,
19200, 38400, 57600, or 115200.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
line console Enters the console terminal configuration mode.
show running-config Displays the running configuration.
To Next Page
Loading...
