Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
7-7
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 7 System Management Commands
logging console
logging console
Use the logging console command to enable logging messages to the console session.
To disable logging messages to the console session, use the no form of this command.
logging console [severity-level]
no logging console
Syntax Description
Command Default None
Command Modes Configuration mode
Command History
Examples This example shows how to enable logging messages with a severity level of 4 (warning) or higher to
the console session:
switch# configure terminal
switch(config)# logging console 4
Related Commands
severity-level (Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
• 0—emergency: System unusable
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
• 5—notification: Normal but significant condition
• 6—informational: Informational message only
• 7—debugging: Appears during debugging only
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show logging console Displays the console logging configuration.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English