Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
3-22
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 3 Ethernet Show Commands
show spanning-tree bridge
show spanning-tree bridge
To display status and configuration of the local bridge, use the show spanning-tree bridge command.
show spanning-tree bridge [address | brief | detail | forward-time | hello-time | id | max-age |
priority [system-id] | protocol]
Syntax Description
Command Default None
Command Modes EXEC mode
Command History
Examples This example shows display STP information for the bridge:
switch# show spanning-tree bridge
Related Commands
address (Optional) Displays the MAC address for the STP local bridge.
brief (Optional) Displays a brief summary of the status and configuration for the
STP bridge.
detail (Optional) Displays a detailed summary of the status and configuration for
the STP bridge.
forward-time (Optional) Displays the STP forward delay interval for the bridge.
hello-time (Optional) Displays the STP hello time for the bridge.
id (Optional) Displays the STP bridge identifier for the bridge.
max-age (Optional) Displays the STP maximum-aging time for the bridge.
priority (Optional) Displays the bridge priority for this bridge.
system-id (Optional) Displays the bridge priority with the system ID extension for this
bridge.
protocol (Optional) Displays whether the Rapid PVST+ or MST protocol is active.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree Displays information STP.
show spanning-tree
active
Displays information about STP active interfaces only.
show spanning-tree
brief
Displays brief summary information about STP.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English