Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-43
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fabric-binding enable
fabric-binding enable
To enable fabric binding in a VSAN, use the fabric-binding enable command. To disable fabric binding,
use the no form of the command.
fabric-binding enable
no fabric-binding enable
Syntax Description This command has no other arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History
Usage Guidelines Fabric binding is configured on a per-VSAN basis.
The fabric binding feature must be enabled in each switch in the fabric that participate in the fabric
binding.
Examples The following example enables fabric binding on that switch:
switch(config)# fabric-binding enable
The following example disables fabric binding on that switch:
switch(config)# no fabric-binding enable
Related Commands
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
fabric-binding activate Activates fabric-binding.
fabric-binding database Configures a fabric-binding database.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English