Send comments to nx5000-docfeedback@cisco.com
9-56
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 9 Fibre Channel Show Commands
show zoneset
show zoneset
To display the configured zone sets, use the show zoneset command.
show zoneset [active [vsan vsan-id] | brief [active [vsan vsan-id] | vsan vsan-id] | name
zoneset-name [active [vsan vsan-id] | brief [active [vsan vsan-id] | vsan vsan-id] | vsan
vsan-id] | pending [active [vsan vsan-id] | brief [active [vsan vsan-id] | vsan vsan-id] | vsan
vsan-id] | vsan vsan-id
Syntax Description
Command Default None
Command Modes EXEC mode.
Command History
Examples The following example displays configured zone set information:
switch# show zoneset vsan 1
The following example displays configured zone set information for a specific VSAN:
switch# show zoneset vsan 2-3
active (Optional) Displays only active zone sets.
vsan vsan-id (Optional) Displays the VSAN. The range is 1 to 4093
brief (Optional) Displays zone set members in a brief list.
name zoneset-name (Optional) Displays members of a specified zone set.
pending (Optional) Displays zone sets members that are in session.
Release Modification
4.0(0)N1(1a) This command was introduced.
To Next Page
Loading...
