Send comments to nx5000-docfeedback@cisco.com
2-64
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
spanning-tree mst max-hops
spanning-tree mst max-hops
To specify the number of possible hops in the region before a bridge protocol data unit (BPDU) is discarded,
use the spanning-tree mst max-hops command. To return to the default settings, use the no form of this
command.
spanning-tree mst max-hops hop-count
no spanning-tree mst max-hops
Syntax Description
Command Default 20 hops.
Command Modes Configuration mode
Command History
Examples This example shows how to set the number of possible hops:
switch(config)# spanning-tree mst max-hops 25
Related Commands
hop-count Number of possible hops in the region before a BPDU is discarded; the range of valid
values is from 1 to 255 hops.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show spanning-tree
mst
Displays the information about the MST protocol.
To Next Page
Loading...
