Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference

Send comments to nx5000-docfeedback@cisco.com
8-86
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
fspf hello-interval
fspf hello-interval
To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use
the no form of the command.
fspf hello-interval seconds vsan vsan-id
no fspf hello-interval seconds vsan vsan-id
Syntax Description
Command Default 20 seconds.
Command Modes Interface configuration mode
Command History
Usage Guidelines This command is not applicable to virtual Fibre Channel interfaces.
This command configures FSPF for the specified Fibre Channel interface. This value must be the same
in the ports at both ends of the ISL.
Examples The following example configures a hello interval of 3 seconds on VSAN 1:
switch(config)# interface fc 2/1
switch(config-if)# fspf hello-interval 3 vsan 1
Related Commands
hello-interval seconds Specifies the FSPF hello-interval in seconds. The range is 2 to 65535.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show fspf interface Displays information for each selected interface.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English